Non-Contact shield retained in outer ring,Low ingress of contaminants.Mainly used for miniature ball bearings or Thin Ball Bearing.

Most Sizes ar availabel with metal shileds, Shields are designed to prevent larger particles from entering the bearing and also to keepgrease inside the bearing. They are secured in the outer rings with a steel snap rings. These are removable shields. As the shields make no contact with the inner ring, they do not increase starting or running torque. Shields on miniature bearings are generally made fromSPCC,1Cr18Ni9 stainless steel.

 

 

Metal shield— ZZ —- Without Snap Ring

Non-Contact shield pressed into outer ring.In order to reduce lubricant leakage and keep low ingress of contaminants.This shield design do not increase torque. These are non-removable shields. Mainly used for deep groove ball bearing( Bore>12.00 mm).  Shields on deep groove ball bearings are generally made from SPCC plate.

 

 

Rubber seal—-RS—- little contact inner ring.

Rubber seal pressed into outer ring, and provide a little contact into the innner rings.

It provide an effective seal against very smaller particles such as dust and moisture while preventing lubricant leakage. Contact seals produce much higher frictional torque levels than shields and reduce the maximum speed of a bearing.  But it greatly increase bearing torqure.

This seal are consists of Nitrible Rubber bonded to a metal washers.  This design can be used for most of deep groove ball bearings including miniature bearings(Bore < 12.00mm)

 

 

Rubber seal—-RU—-Non-contact inner ring.

Rubber seal fitted into outer ring with a snap without contacted into inner ring. It would be high speed, They offer superior protection over metal shields but do not provide as effective as seal as contact type.

Due to non-contact design,This bearing can be used for high speed applications,These seals are also made Nitrible Rubber bonded to a metal washers.

 

 

Teflon seal —-TS — little contact inner and outer rings.

The inner lip of the seal rubs against the bearing inner ring to provide an effective seal against smaller particles such as dust and moisture while preventing lubricant leakage. Contact seals produce much higher frictional torque levels than shields and reduce the maximum speed of a bearing.

This seal are made from teflon seal with glass fibre reinfored. Manly used for miniature ball bearings.Seal can flex to accommodate internal pressure changes.Seal can flex to accommodate internal pressure changes.

Best protection agaist contamination and reduced lubricant leakage. However it is very low speed.